RTK F9P Positioning Solutions
  • Introduction
  • What is RTK?
    • GPS Location
  • The RTK Base
    • Choosing a base module
    • Auto conf (QGControl / MP)
    • Configuring the base manually
    • LED Signals
  • The RTK Rover
    • Choosing a rover module
    • Auto conf (QGControl / MP)
    • Configuring the rover manually
  • RTK F9P Drotek Modules
    • DP0601
      • Hardware
        • Drawing
          • V1
          • V1.1
          • V1.2
        • Pinouts
          • V1
          • V1.1
          • V1.2
      • Software
    • Sirius RTK GNSS Base (F9P)
      • Hardware
        • Drawing
        • Pinouts
        • LED Signals
      • Software
    • Sirius RTK GNSS Rover (F9P)
      • Hardware
        • Drawing
        • Pinouts
      • Software
    • DP0602
      • Hardware
        • Drawing
        • Pinouts
      • Software
  • How to get started
    • ZED-F9P RTK configuration
    • Pixhawk 3 PRO (EOLA) integration
    • Telemetry integration
  • Tutorials
    • Set Baudrates
    • Set Nav update rate
    • Set Survey-in time & position accuracy limit
    • Set Fixed LLH or ECEF
    • Change GNSS constellations
    • Updating ZED-F9P Firmware
    • Setup RTK solution using a local network
    • Install U-blox drivers
    • Precise Post Processing (PPP)
  • Frequently Asked Questions
Powered by GitBook
On this page

Was this helpful?

  1. Tutorials

Install U-blox drivers

PreviousSetup RTK solution using a local networkNextPrecise Post Processing (PPP)

Last updated 2 years ago

Was this helpful?

Pre-requisites :

  1. Download U-blox generic drivers : https://www.u-blox.com/sites/default/files/products/tools/UBX-GNSS-CDC-ACM-windows_Driver_%28UBX-drv-v1.2.0.8%29.exe.zip

  2. Install the “ubloxGnss_usbcdc_windows_3264_v1.2.0.8.exe” file

Installing the driver :

  1. Go to the Windows device manager

2. Right Click onto the COM port related to your u-blox product, then select “Update Driver” :

3. Click on “Browse my computer for driver software” :

4. Then click on “let me pick from a list…”, then Next :

5. On the left panel click onto “u-blox AG”, then on the right side, click on “u-blox GNSS Receiver”, then Next :

6. A warning message will pop-up. Click on “yes” :

7. Everything is now installed properly, you can click on “Close”

You have successfully installed U-blox drivers !