Set color
Last updated
Last updated
Set color add on the selected drones a transition from the current color of the drones to the Color chosen in a certain Duration using the selected Interpolation.
You can choose the color with the color wheel.
The white LED is linked to the A parameter
You must select which drones you set the color.
Duration is the duration of the color transition.
If Duration is equal to 0, a single color keyframe with constant interpolation will be added.
If Duration is superior to 0, two color keyframes will be added with the Interpolation chosen.
Constant, switch instantly from one color to the other at the end of Duration.
Linear, switch linearly from one color to the other according to the Duration.
Bezier, switch from one color to the other more smoothly than with Linear.
Change interpolation change the current color interpolation to the Interpolation chosen for the selected drones.
With the eyedropper next to Color and New color, you can pick the color of a drone color keyframe.
You must select one drone only, go to a frame where there is a color keyframe, then click on the eyedropper Pick color.
Swap color replace all the color keyframes of the color Color by the color New color.
Swap color is only applied on the selected drones and on the color keyframes in the scene range (between Start and End).
Set brightness factor to the value you want to multiply your current brightness with.
Brightness is previously initialized with set color. If brightness is over 1, it will be set to 1 and a warning is displayed. All drones will be affected independently.
Brightness factor over 1 will increase the brightness value.
Brightness factor under 1 will decrease the brightness value.
Remove white is used to remove the white LEDs on the selected drones on the color keyframes in the scene range.
This is mainly used when white LEDs have been added accidentally.