Voltage & current sensor board
This module can measure the battery voltage and current consumption with effect Hall sensor. It’s compatible with Dropix and Pixhawk flight controller.

Hardware

How to plug to Dropix autopilot?

Software

Setting for measuring current / voltage in Mission Planner

In “Initial Setup”, select “Battery Monitor” and change the values:
Monitor : Voltage and Current
Sensor : Other
APM Ver : Pixhawk
Voltage Divider : 15,55
Amper per volt : 151,5
Don’t forget to change the “BATT_AMP_OFFSET” parameter.
You can check all information in real time in the “Flight Data” page.
Last modified 2yr ago